• Strain gauge to RS485 or CAN digital load cell converter
• Low profile, small 19 mm diameter for mounting inside sensor
• Auto calibration or direct entry of mV/V with linearisation
• Ultra high performance, resolution of 1 part in 200,000 (18bit)
• High performance, resolution 1 part in 200,000
• Error reporting including strain gauge fault conditions
• Programmable dynamic filter
• A miniature digital temperature sensor module for wiring to DCell/DSC temperature sensor pcb board is also available (shown on thumbnail image on left) 
• Option of an in-line enclosure (shown on thembnail image on left)
• ATEX component approval for hazardous zone 2 
• FREE ! – Software enabling 24 DCell or DSCs to be viewed and logged simultaneously – see more here

Very high performance embedded digital load cell converter or strain gauge digitizer module signal converter supplied in a miniature format designed specifically to be incorporated directly into strain gauge sensors such as load cells, pressure transducers and torque sensors. The DCell offers high speed and high precision digitizing capabilities, along with linearization and temperature compensation.

The DCell has conversion of standard strain gauge load cells to digital load cells.

This high performance digital load cell converter embeds directly into a load cell, pressure transducers & torque sensors

The DCell is available output formats include the RS485, ASCII, Modbus, MantraCAN (J1939). All are 4 wire bus and power formats offering connection of up to 32 sensors on just 4 wires. 



DCell Additional features are:-

Remote shunt calibration

Temperature compensation

Peak and trough recording

Long cable lengths up to 1000m

Full Details Here