Votre leader canadien en instrumentation depuis 1946.

Sonde de température en continu à résistance de platine

The ST-300 is a 1/10 DIN platinum resistance thermometer (PRT), consisting of a platinum resistive element enclosed in a stainless steel sheath, and lead wires to connect the sensor to a measurement device. ST-300 sensors are weatherproof and designed for continuous air temperature measurement when housed in an aspirated radiation shield, such as the TS-100 […]

  • SKU : E-804-ST-300-SS
  • Fabricant : Apogee
Posez une question sur ce produit

The ST-300 is a 1/10 DIN platinum resistance thermometer (PRT), consisting of a platinum resistive element enclosed in a stainless steel sheath, and lead wires to connect the sensor to a measurement device. ST-300 sensors are weatherproof and designed for continuous air temperature measurement when housed in an aspirated radiation shield, such as the TS-100 fan aspirated radiation shield.

Calibration Uncertainty: -50 to 70 C
Measurement Repeatability: 0.1 C from -40 to 60 C (1/10 DIN)
Measurement Repeatability: < 0.01 C
Non-stability (Long-term Drift): <0.05 C per year (when used in non-condensing environments where the annual average temperature is less than 30 C; continuously high temperatures or continuously humid environments increase drift rate)
Equilibration Time: 15 seconds
Self-Heating: < 0.01 C (typical, assuming pulsed excitation of 2.1 V DC); 0.09 C at 5 C (maximum, assuming continuous input excitation of 2.1 V DC)
Operating Environment: -50 to 70 C, 0 to 100 % relative humidity
Input Voltage Requirement: 2.1 V DC
Output Voltage Range: 16 to 27 mV DC (assuming input excitation of 2.1 V DC)
Current Drain: 0.21 mA DC (maximum, assuming continuous input excitation of 2.1 V DC)
Dimensions: 65 mm length, 3 mm diameter
Mass: 95 g
Cable: 5 m of four conductor, shielded, twisted-pair wire. Additional cable available in multiples of 5 m. Santoprene rubber jacket (high water resistance, high UV stability, flexibility in cold conditions). Pigtail lead wires.

Click here to view a video on Best Practices for Air Temperature Measurement

Full Details Here