Honeywell’s universal in line amplifiers supply a highly regulated bridge excitation voltage for the transducer and convert the millivolt signal of the transducer to either a 0 to 0 to ±5 V, 0 to ±10 V, or 4 mA to 20 mA two or three-wire output. The universal series in-line amplifier features two selectable excitation voltages, programmable gain settings, a wide adjustment range on the zero, and a buffered solid-state shunt cal relay for quick calibration. Honeywell also offers charge amplifiers for charge-mode piezo-electronic transducers to require charge amplifiers to convert their output to useful levels.

• Strain gauge sensor or piezo-electric accelerometer amplifiers
• 8 Vdc to 32 Vdc, 18 Vdc to 32 Vdc, ±15 Vdc or 24 Vdc to 32 Vdc supply voltage
• ±5, ±10, ±15 Vdc or 4mA to 20 mA two or three wire output
• Increases signal-to-noise ratio in noisy environments
• NEMA 4 housing

Universal Bi-Polar Strain Gauge In-Line Amplifier; 24 to 32 Single Voltage Supply to In-Line Wiring NOTE: (-)OUTPUT is biased approximately 1/3 of the supply voltage. The output will swing 0-10 VDC around the (-)OUTPUT reference voltage.

The Model UBP-10 bi-polar In-Line amplifier supplies a highly-regulated, bridge excitation voltage for the transducer and converts the millivolt signal of the transducer to a ±10 Vdc signal. (-)OUTPUT is biased approximately 1/3 of the supply voltage. The output will swing 0-10 VDC around the (-)OUTPUT reference voltage. The universal, in-line amplifier features three selectable excitation voltages, programmable gain settings, wide adjustment range on the zero and a buffered solid-state shunt cal relay for quick calibration.

Model:UBP-10

Order Code:BE126

Full Details Here