Canada’s Instrumentation Leader Since 1946.

Hydraulic Solid Load Cell

The Geosense® HLC-6050 series of Hydraulic Load Cells consist of a sensitive pressure pad formed by joining two stiff steel discs at their periphery. The void inside the cell is filled with de-aired fluid. When load is applied to the cell the pressure of the inside liquid changes. The changes in pressure correspond directly to the […]

Ask us about this item

The Geosense® HLC-6050 series of Hydraulic Load Cells consist of a sensitive pressure pad formed by joining two stiff steel discs at their periphery. The void inside the cell is filled with de-aired fluid. When load is applied to the cell the pressure of the inside liquid changes. The changes in pressure correspond directly to the load applied.


The pressure in the loads cell is measured either by a manometer, vibrating wire or resistance transducer and are available in the following models:


  • HLC-6050 – Manometer for pressure indication
  • HLC-6051 – Vibrating wire transducer
  • HLC-6052 – Resistance transducer


Models HLC-6051/2 can be read with portable manual readouts, connected into a GeoLogger or Wi-SOS 480 automatic data acquisition system.


Mounting surfaces should be flat and parallel for optimum performance and the use of very stiff bearing plates and load distribution plates is recommended.


The Geosense® HLC-6050 series is typically used to measure and monitor compressive load or force in structural members, struts and piles.
















Range (kN) 1000, 2000, 3000, 5000, 10000
Non linearity ± 1% FS
Over range 150%
Excitation 10V DC
Output 1.5mV/V
Bridge resistance 1400 Ohms
Number of sensors 16
Material Stainless steel
Temperature range -20 to + 70ºC
Capacity (kN) 250, 500, 750, 1000, 1250, 1500, 2000, 3000, 4000, 5000
Diameter (mm) 107, 145, 174, 198, 219, 239, 273, 331, 380, 423
Height 30mm